Features
1.Cycle progresses automatically by control system through conditioning, sterilizing, exhaust, drying and venting phases.
2.There are two sterilize temperature for selection, 121 degree C/132 degree C. When setting temperature is achieved the process of sterilizing cycle will automatic operating.
3.Sterilize time is adjustable from 0~30minutes on sterilizing timer and drying time is adjustable from 0~30minutes on drying timer.
4.The timer starts only after the pre-set temperature is reached, ensuring complete sterilization.
5.A buzzer announces the completion and cuts off the heating power source.
6.The pressure-temperature gauge make ideal require reading and indicate high precision and consistent results.
7.Integral heating system is equipped with a high efficient immersion heater and temperature switch to provide strict control of heating temperature.
8.Specially designed pre-heating device to pre-heat the chamber before operation and ensures efficient heating and drying functions.
9.Automatic air venting device discharges cool air from chamber to obtain effective saturated steam.
10.Large water reservoir supply water consumption of several sterilizing cycle.
11.Chamber door is manually operated and actuated by rotating a door handle.
12.The silicone-rubber sealing gasket is applied to an even pressure door seal.
13.Cylindrical chamber provides a high capacity to satisfy a wide range of sterile processing needs.
14.Chamber is made of high quality SUS 304 stainless steel with polished surface for long lasting service and easy cleaning. Chamber construction is thermally insulated with foil backed fiberglass insulation.
Safety devices
1.Safty door switch: cycle does not start unless chamber is locked.
2.Safety valve: releasing steam in case of excessive chamber pressure.
3.Overheating protection device: high temperature deviation in chamber actuates protective device cuts off the heating source immediately.
4.Circuit protection device: fuse protects control units when short circuit or overload occurs.
5.Emergency exhaust: manual exhaust to vent the chamber and remove the load in the event of a power outage.
